http://libir.tmu.edu.tw/bitstream/987654321/43034/1/4.pdf

Review of second-order models for adsorption systems.

Heavy metal pollution is a major problems in the environment. The impact of toxic metal ions can be minimized by different technologies, viz., chemical precipitation, membrane filtration, oxidation, reverse osmosis, flotation and adsorption. But among them, adsorption was found to be very efficient and common due to the low concentration of metal uptake and economically feasible properties. Cellulosic materials are of low cost and widely used, and very promising for the future. These are available in abundant quantity, are cheap and have low or little economic value. Different forms of cellulosic materials are used as adsorbents such as fibers, leaves, roots, shells, barks, husks, stems and seed as well as other parts also. Natural and modified types of cellulosic materials are used in different metal detoxifications in water and wastewater. In this review paper, the most common and recent materials are reviewed as cellulosic low-cost adsorbents. The elemental properties of cellulosic materials are also discussed along with their cellulose, hemicelluloses and lignin contents.

/pdf/removal-of-heavy-metals-from-emerging-cellulosic-low-cost-3gyrdiya7u.pdf

Removal of heavy metals from emerging cellulosic low-cost adsorbents: a review

Fresh water accounts for 3% of water resources on the Earth. Human and industrial activities produce and discharge wastes containing heavy metals into the water resources making them unavailable and threatening human health and the ecosystem. Conventional methods for the removal of metal ions such as chemical precipitation and membrane filtration are extremely expensive when treating large amounts of water, inefficient at low concentrations of metal (incomplete metal removal) and generate large quantities of sludge and other toxic products that require careful disposal. Biosorption and bioaccumulation are ecofriendly alternatives. These alternative methods have advantages over conventional methods. Abundant natural materials like microbial biomass, agro-wastes, and industrial byproducts have been suggested as potential biosorbents for heavy metal removal due to the presence of metal-binding functional groups. Biosorption is influenced by various process parameters such as pH, temperature, initial concentration of the metal ions, biosorbent dose, and speed of agitation. Also, the biomass can be modified by physical and chemical treatment before use. The process can be made economical by regenerating and reusing the biosorbent after removing the heavy metals. Various bioreactors can be used in biosorption for the removal of metal ions from large volumes of water or effluents. The recent developments and the future scope for biosorption as a wastewater treatment option are discussed.

/pdf/application-of-biosorption-for-removal-of-heavy-metals-from-2wwi5v412f.pdf

Application of Biosorption for Removal of Heavy Metals from Wastewater

The adsorption behavior of rice husk for cadmium ions from aqueous solutions has been investigated as a function of appropriate equilibrium time, adsorbent dose, temperature, adsorbate concentrations and pH in a batch system. Studies showed that the pH of aqueous solutions affected cadmium removal with the result that removal efficiency increased with increasing solution pH. The maximum adsorption was 98.65% at solution pH 6, contact time 60 min and initial concentration of 25 mg/L. The experimental data were analysed by the Langmuir, Freundlich and Temkin models of adsorption. The characteristic parameters for each isotherm and related correlation coefficients have been determined. Thermodynamic parameters such as, and have also been evaluated and it has been found that the sorption process was feasible, spontaneous and exothermic in nature. The kinetics of the sorption were analysed using the pseudo-first order and pseudo-second order kinetic models. Kinetic parameters, rate constants, equilibrium sorption capacities and related correlation coefficients for each kinetic model were calculated and discussed. It was shown that the adsorption of cadmium could be described by the pseudo-second order equation, suggesting that the adsorption process is presumably a chemisorption. The rice husk investigated in this study showed good potential for the removal of cadmium from aqueous solutions. The goal for this work is to develop inexpensive, highly available, effective metal ion adsorbents from natural waste as alternative to existing commercial adsorbents.

/pdf/thermodynamic-and-kinetic-studies-of-cadmium-adsorption-from-34o1yoh4tm.pdf

Thermodynamic and kinetic studies of cadmium adsorption from aqueous solution onto rice husk

The need to clean-up heavy metal contaminated environment can not be over emphasized. This paper describes the adsorption isotherm studies of Cd (II), Pb (II) and Zn (II) ions from aqueous solution using unmodified and EDTA-modified maize cob. Maize cob was found to be an excellent adsorbent for the removal of these metal ions. The amount of metal ions adsorbed increased as the ini- tial concentration increased. Also, EDTA - modification enhanced the adsorption capacity of maize cob probably due to the chelating ability of EDTA. Among the three adsorption isotherm tested, Dubinin- Radushkevich gave the best fit with R2 value ranging from 0.9539 to 0.9973 and an average value of 0.9819. This is followed by Freundlich isotherm (Ave. 0.9783) and then the Langmuir isotherm (Ave. 0.7637). The sorption process was found to be a physiosorption process as seen from the apparent ener- gy of adsorption which ranged from 2.05KJ\mol to 4.56KJ\mol. Therefore, this study demonstrates that maize cob which is an environmental pollutant could be used to adsorb heavy metals and achieve cleanliness thereby abating environmental nuisance caused by the maize cob.

/pdf/adsorption-isotherm-studies-of-cd-ii-pb-ii-and-zn-ii-ions-2a1085dv0z.pdf

Adsorption isotherm studies of Cd (II), Pb (II) and Zn (II) ions bioremediation from aqueous solution using unmodified and EDTA-modified maize cob

that the phytosorption rates could be described better by a pseudo-second order process and the rate coefficients was determined to be 2.04 × 10 −3 min −1 and 1.98 × 10 −3 min −1 for Cu 2+ and Cd 2+ respectively. The results from these studies indicated that acid treated cassava waste bi omass could be an efficient sorbent for the removal of toxic and valuable metals from industrial effluents.

/pdf/studies-on-the-influence-of-mercaptoacetic-acid-maa-qavjx3sqza.pdf

Studies on the influence of mercaptoacetic acid (maa) modification of cassava (manihot sculenta cranz) waste biomass on the adsorption of cu2+ and cd2+ from aqueous solution

A A Abia

Papers

Studies on the influence of mercaptoacetic acid (maa) modification of cassava (manihot sculenta cranz) waste biomass on the adsorption of cu2+ and cd2+ from aqueous solution