/pdf/self-assembled-monolayers-of-thiolates-on-metals-as-a-form-1neb0hj3k4.pdf

Self-assembled monolayers of thiolates on metals as a form of nanotechnology.

The interest in nanoscale materials stems from the fact that new properties are acquired at this length scale and, equally important, that these properties * To whom correspondence should be addressed. Phone, 404-8940292; fax, 404-894-0294; e-mail, mostafa.el-sayed@ chemistry.gatech.edu. † Case Western Reserve UniversitysMillis 2258. ‡ Phone, 216-368-5918; fax, 216-368-3006; e-mail, burda@case.edu. § Georgia Institute of Technology. 1025 Chem. Rev. 2005, 105, 1025−1102

Chemistry and properties of nanocrystals of different shapes.

We demonstrate that semiconductor nanorods can be used to fabricate readily processed and efficient hybrid solar cells together with polymers. By controlling nanorod length, we can change the distance on which electrons are transported directly through the thin film device. Tuning the band gap by altering the nanorod radius enabled us to optimize the overlap between the absorption spectrum of the cell and the solar emission spectrum. A photovoltaic device consisting of 7-nanometer by 60-nanometer CdSe nanorods and the conjugated polymer poly-3(hexylthiophene) was assembled from solution with an external quantum efficiency of over 54% and a monochromatic power conversion efficiency of 6.9% under 0.1 milliwatt per square centimeter illumination at 515 nanometers. Under Air Mass (A.M.) 1.5 Global solar conditions, we obtained a power conversion efficiency of 1.7%.

http://science.sciencemag.org/content/sci/295/5564/2425.full.pdf

Hybrid Nanorod-Polymer Solar Cells

The extinction coefficient per mole of nanocrystals at the first exitonic absorption peak, e, for high-quality CdTe, CdSe, and CdS nanocrystals was found to be strongly dependent on the size of the nanocrystals, between a square and a cubic dependence. The measurements were carried out using either nanocrystals purified with monitored purification procedures or nanocrystals prepared through controlled etching methods. The nature of the surface ligands, the refractive index of the solvents, the PL quantum yield of the nanocrystals, the methods used for the synthesis of the nanocrystals, and the temperature for the measurements all did not show detectable influence on the extinction coefficient for a given sized nanocrystal within experimental error.

Experimental Determination of the Extinction Coefficient of CdTe, CdSe, and CdS Nanocrystals

We describe the development of multifunctional nanoparticle probes based on semiconductor quantum dots (QDs) for cancer targeting and imaging in living animals. The structural design involves encapsulating luminescent QDs with an ABC triblock copolymer and linking this amphiphilic polymer to tumor-targeting ligands and drug-delivery functionalities. In vivo targeting studies of human prostate cancer growing in nude mice indicate that the QD probes accumulate at tumors both by the enhanced permeability and retention of tumor sites and by antibody binding to cancer-specific cell surface biomarkers. Using both subcutaneous injection of QD-tagged cancer cells and systemic injection of multifunctional QD probes, we have achieved sensitive and multicolor fluorescence imaging of cancer cells under in vivo conditions. We have also integrated a whole-body macro-illumination system with wavelength-resolved spectral imaging for efficient background removal and precise delineation of weak spectral signatures. These results raise new possibilities for ultrasensitive and multiplexed imaging of molecular targets in vivo.

/pdf/in-vivo-cancer-targeting-and-imaging-with-semiconductor-37h9ua8h1g.pdf

In vivo cancer targeting and imaging with semiconductor quantum dots

Nanometre-size inorganic dots, tubes and wires exhibit a wide range of electrical and optical properties1,2 that depend sensitively on both size and shape3,4, and are of both fundamental and technological interest In contrast to the syntheses of zero-dimensional systems, existing preparations of one-dimensional systems often yield networks of tubes or rods which are difficult to separate5,6,7,8,9,10,11,12 And, in the case of optically active II–VI and III–V semiconductors, the resulting rod diameters are too large to exhibit quantum confinement effects6,8,9,10 Thus, except for some metal nanocrystals13, there are no methods of preparation that yield soluble and monodisperse particles that are quantum-confined in two of their dimensions For semiconductors, a benchmark preparation is the growth of nearly spherical II–VI and III–V nanocrystals by injection of precursor molecules into a hot surfactant14,15 Here we demonstrate that control of the growth kinetics of the II–VI semiconductor cadmium selenide can be used to vary the shapes of the resulting particles from a nearly spherical morphology to a rod-like one, with aspect ratios as large as ten to one This method should be useful, not only for testing theories of quantum confinement, but also for obtaining particles with spectroscopic properties that could prove advantageous in biological labelling experiments16,17 and as chromophores in light-emitting diodes18,19

Shape control of CdSe nanocrystals

Nanoscale materials are currently being exploited as active components in a wide range of technological applications in various fields, such as composite materials1,2, chemical sensing3, biomedicine4,5,6, optoelectronics7,8,9 and nanoelectronics10,11,12. Colloidal nanocrystals are promising candidates in these fields, due to their ease of fabrication and processibility. Even more applications and new functional materials might emerge if nanocrystals could be synthesized in shapes of higher complexity than the ones produced by current methods (spheres, rods, discs)13,14,15,16,17,18,19. Here, we demonstrate that polytypism, or the existence of two or more crystal structures in different domains of the same crystal, coupled with the manipulation of surface energy at the nanoscale, can be exploited to produce branched inorganic nanostructures controllably. For the case of CdTe, we designed a high yield, reproducible synthesis of soluble, tetrapod-shaped nanocrystals through which we can independently control the width and length of the four arms.

Controlled growth of tetrapod-branched inorganic nanocrystals

We report the preparation and structural characterization of core/shell CdSe/CdS/ZnS nanorods. A graded shell of larger band gap is grown around CdSe rods using trioctylphosphine oxide as a surfactant. Interfacial segregation is used to preferentially deposit CdS near the core, providing relaxation of the strain at the core/shell interface. The reported synthesis allows for variation of the shell thickness between one and six monolayers, on core nanorods ranging from aspect ratios of 2:1 to 10:1. After an irreversible photochemical annealing process, the core/shell nanorods have increased quantum efficiencies and are stable in air under visible or UV excitation. In addition to their robust optical properties, these samples provide an opportunity for the study of the evolution of epitaxial strain as the shape of the core varies from nearly spherical to nearly cylindrical.

Epitaxial growth and photochemical annealing of graded CdS/ZnS shells on colloidal CdSe nanorods.

Nanocomposite photovoltaic devices are provided that generally include semiconductor nanocrystals as at least a portion of a photoactive layer. Photovoltaic devices and other layered devices that comprise core-shell nanostructures and/or two populations of nanostructures, where the nanostructures are not necessarily part of a nanocomposite, are also features of the invention. Varied architectures for such devices are also provided including flexible and rigid architectures, planar and non-planar architectures and the like, as are systems incorporating such devices, and methods and systems for fabricating such devices. Compositions comprising two populations of nanostructures of different materials are also a feature of the invention.

Nanostructure and nanocomposite based compositions and photovoltaic devices

The transition between four- and six-coordinate structures in CdSe nanocrystals displays simple transition kinetics as compared with the extended solid, and we determined activation volumes from the pressure dependence of the relaxation times. Our measurements indicate that the transformation takes place by a nucleation mechanism and place strong constraints on the type of microscopic motions that lead to the transformation. The type of analysis presented here is difficult for extended solids, which transform by complicated kinetics and involve ill-defined domain volumes. Solids patterned on the nanoscale may prove to be powerful models for the general study of structural transitions in small systems, as well as in extended solids.

https://science.sciencemag.org/content/sci/293/5536/1803.full.pdf

Erik C. Scher

Papers

Shape control of CdSe nanocrystals

Controlled growth of tetrapod-branched inorganic nanocrystals

Epitaxial growth and photochemical annealing of graded CdS/ZnS shells on colloidal CdSe nanorods.

Nanostructure and nanocomposite based compositions and photovoltaic devices

Activation volumes for solid-solid transformations in nanocrystals.